Metrohm tiamo 2.2 Manual - Manual (Page 1304)

6.7 Subwindow Sensors ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1290 ￭￭￭￭￭￭￭￭ tiamo 2.2
pH(0)/E(0)
Electrode zero point of the sensor.
Next calibration
Date on which the next calibration is to be carried out. If calibration data
monitoring is switched on and if the set date is before the current date (i.e.
the calibration has not yet been carried out) then the date will be shown in
red.
Additional columns from the Sensor properties can be shown with the menu
item Edit
▶ Column display.
Note
Lines that contain red entries will also show the line number with a red
background.
Table view
The sensor table cannot be edited directly. With a click on the column title
the table can be sorted according to the selected column in either increasing
or decreasing sequence. The table view can be adapted with the left-hand
mouse button as follows:
￭ Drag the margin between column titles:
Sets the column width
￭ Double-click on the margin between column titles:
Sets the optimal column width
￭ Drag the column title:
Moves the column to the required location
If the contents of a field is larger than the column width then the whole
contents will be shown as a tooltip if the mouse cursor is kept on the field.
Functions
The menu Edit beneath the sensor table contains the following menu items:
New… Adds new sensor manually (see Chapter 6.7.2.3, page 1291).
Delete Deletes the selected sensor (see Chapter 6.7.2.4, page 1292).
Properties… Edits the selected sensor (see Chapter 6.7.3.1, page 1293).
Column display… Defines columns for the sensor table(see Chapter 6.7.2.2, page 1291)
Print (PDF)… Outputs the sensor table as a PDF file(see Chapter 6.7.2.5, page 1292)