Metrohm tiamo 2.2 Manual - Manual (Page 1060)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1046 ￭￭￭￭￭￭￭￭ tiamo 2.2
If the option not defined is selected as Device name, any device types or
device groups which are able to execute the command can be selected,
independently of the devices in the device table.
Selection Device types | Titrando
Default value Titrando
Sensor
Measuring input
Selection of the measuring input to which the sensor is connected.
Titrando
Selection
1 | 2
Default value 1
855
Selection
1
Default value 1
Sensor
Selection of an ISE sensor from the ISE sensors available in the sensor table.
Selection 'Sensor name' | ISE electrode
Default value ISE electrode
Temperature measurement
Type of temperature measurement
Selection continuous | automatic | off
Default value automatic
continuous
A temperature sensor must be connected. The temperature will then be
measured continuously.
automatic
If a temperature sensor is connected then the temperature will be meas-
ured continuously. Otherwise, the temperature entered manually under
Temperature will be used.
off
The temperature will not be measured. The temperature entered man-
ually under Temperature will be used.
Stirrer
Stirrer
Selection of the stirrer.