Metrohm tiamo 2.2 Manual - Manual (Page 1402)

7.9 774 Oven Sample Processor ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1388 ￭￭￭￭￭￭￭￭ tiamo 2.2
Acoustic signal
on | off (Default value: off)
If this option is enabled, an acoustic signal will be emitted additionally to the
message defined above
Action
The actions can only be edited if monitoring is switched on.
If during monitoring it is found that the validity period has expired then one
of the following actions will be triggered automatically at Start test.
Selection Record message | Display message | Stop deter-
mination
Default value Display message
Record message
The message that the validity period has expired will be automatically
saved with the determination.
Display message
A message is displayed and you can choose whether you want to con-
tinue the run or cancel it. If the run is continued then the message that
the validity period has expired will be automatically saved with the deter-
mination.
Stop determination
The running determination will be automatically terminated. The follow-
ing message must be confirmed with [OK].
7.9 774 Oven Sample Processor
7.9.1 774 Oven Sample Processor - Overview
Dialog window: Configuration ▶ Devices ▶ [Edit] ▶ Properties ▶ Properties - 'Device
type' - 'Device name'
The parameters for the device 774 Oven Sample Processor are set on
the following tabs:
￭ General
General device information such as device name, device type, serial num-
ber, etc.
￭ Tower
Properties of the tower. This tab is only displayed if the Oven Sample
Processor is connected to the PC via an RS-232 interface.
￭ Rack
Information on the rack attached. This tab is only displayed if the Oven
Sample Processor is connected to the PC via an RS-232 interface.