Metrohm tiamo 2.2 Manual - Manual (Page 1198)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1184 ￭￭￭￭￭￭￭￭ tiamo 2.2
Command variables
The following command variables are generated in the method run by the
command CALL and can be used in formulas under the designation 'Com-
mand name.Variable designation':
Identifi-
cation Description
.BSY Command status; 1 = BUSY, HOLD or ERROR; 0 =
READY; invalid (variable not available) = Command has
not ever been started
.FIN Command status; 1 = Command has been ended at
least once, 0, invalid (variable not available) = Com-
mand has never been ended
5.6.10.3.2 CALL - Properties
Dialog window: Method ▶ CALL ▶ Properties... ▶ CALL - Call #
Command name
Name of the command.
Input 25 characters
Call table
All the defined calls listed in the table are carried out simultaneously. The
table cannot be edited directly.
Note
The CALL command waits for either the end of the tracks called or the
acknowledgement signal of them. If the completion of a track is not to
be waited for, the option Return immediately must be activated in the
corresponding track command (see Chapter 5.6.2.3, page 432).
[New]
Opens the dialog window Call to enter a new call (see Chapter
5.6.10.3.3, page 1185).
Note
10 calls can be defined at maximum.