Metrohm 840 PC Control 5.0 / Touch Control - Manual (Page 83)

3 Operation
PC Control / Touch Control
71
3.10.9 Bluetooth devices
Connecting a Bluetooth USB adapter to the Titrando is described in
the Installation Instructions for the Titrando. In the device manager you
must configure the Bluetooth adapter used to connect the device.
Look for all the devices within reach with [Find device]. If they are
switched on, they are entered with status ok. Devices which are not
switched on at the moment but once have been assigned to a
printer or a RS-232 interface are entered with status not
available.
Select the adapter connected to the printer or the balance and open
the properties dialog with [Edit].
Select the assignment Printer or COM1...X.
Attention!
If you change the assignment of a Bluetooth adapter, the Touch
Control has to be switched off and on again in order to accept the
change.
You have to configure the printer in the device manager.
Add a printer to the device manager and configure it as described
in Section 3.10.7.