Metrohm 840 PC Control 5.0 / Touch Control - Manual (Page 17)

2 Installation
PC Control / Touch Control
5
2 Installation
Connecting the Touch Control to the Titrando is described in the
manual for the Titrando as well as the setup of the titration system with
peripheral devices such as stirrers and dosing devices.
2.1 Setting up the Touch Control
2.1.1 Packaging
The Touch Control and its specially packed accessories are supplied in
very protective special packaging. Please store this packaging in a safe
place; it is the only way in which the safe transport of the instrument can
be guaranteed.
2.1.2 Checks
Immediately after receipt, check whether the shipment has arrived
complete and without damage by comparing it with the delivery note.
2.1.3 Location
The Touch Control has been designed for internal laboratory use and
should not be used in explosion-endangered locations.
Place the instrument on a suitable vibration-free laboratory bench,
protected as much as possible from corrosive atmospheres and
contact with chemicals.
Choose a location where the temperature is usually between +5 °C and
+40 °C. The instrument should be protected against excessive
variations in temperature and direct sunlight.