Metrohm 840 PC Control 5.0 / Touch Control - Manual (Page 108)

3.14 Templates
96
PC Control / Touch Control
3.14 Templates
You can define system-specific templates for sample data, result
calculations, remote lines, calibration buffers and the report header.
You can use these templates when editing the corresponding data.
Open the dialog System/Templates.
3.14.1 Sample identification list
You can create a system-specific list with templates for sample
identifications. You can select from this list when entering the sample
data Identification 1 and Identification 2 in the main dialog,
during a sample data request (REQUEST command) or in the sample
data silo (see Section 3.19). The sample identification list makes
it easier for you to enter frequently used sample identifications. It may
be a good idea to define the unchanging part of the identification as a
template and to add the variable part during sample data input.
Open the dialog Templates/Sample data.
Open the list of templates for the sample identifications with
[Sample identification list].
Use [New] to define all sample identifications which are to be
available for selection one after the other.