Metrohm 840 PC Control 5.0 / Touch Control - Manual (Page 309)

5 Troubleshooting – Maintenance
PC Control / Touch Control
297
You can use [Back] to switch back again step by step.
When you have checked all the display areas a list of fixed keys
appears; you should touch them in any sequence. If they function
correctly the request will always change to an appropriate message
(e. g. PRINT ok).
You can use [Home] to end the Touch screen test at any time or to
conclude it.
5.2.7 Software update
With the Touch Control you can carry out an update of the instrument
program or load a new dialog language. The instrument program
(firmware) of the control device (Titrando, USB Sample Processor etc.)
can be updated with both the Touch Control and the PC Control.
The procedure for carrying out an update or a new installation of the PC
Control software is described in Section 2.1.2.
Note!
It is essential that the control software (Touch Control or PC Control) is
updated first and then the instrument program of the control device
(Titrando, USB Sample Processor etc.).
Touch Control and PC Control must always be updated at the same
time as the control devices.
Last square to be
touched appears
in green.
Crosshair shows
last recognized
contact point.
Next square to be
touched appears
in red.
Variation of the recognized contact
point from the center of the last
square touched.