Metrohm 840 PC Control 5.0 / Touch Control - Manual (Page 137)

3 Operation
PC Control / Touch Control
125
3.16.11 Save method
You can save the current method in one of three memories (see
Section 3.11).
From the main dialog use [Edit parameter] to open the
command list for the current method. If the use of direct
parameters has been switched on (see Section 3.16.5) then the
direct parameter list will be opened; the method can also be
saved from here.
Use [Save method] to open the dialog for selecting the memory,
file group and file name.
If you have created a new method (see Section 3.15.2) and this has still
not been saved then the dialog Sequence/Save method will look like
this:
Under Memory select the memory location in which the method is to
be saved. Methods can be saved in the Internal memory, on
Card 1 or Card 2 or a shared file system (requires 847 USB Lab
Link, see Section 3.10.11).
In order to arrange your methods they can be stored in different
groups. Enter the Group in which the method is to be saved. You
can also select the group from the list of existing file groups. If the
method has already been stored then the group in which the
method has already been stored will be proposed. The file names
must be unambiguous for each memory location, i.e. you cannot
save a file in different groups with the same name.
Enter a File name for the method. If the method has already been
stored then the name under which the method has already been
saved will be proposed. The method is saved with [Save]. With
[Cancel] and [Back] the method is not saved.