Metrohm 840 PC Control 5.0 / Touch Control - Manual (Page 143)

3 Operation
PC Control / Touch Control
131
The [Calibration data] and [Titrant data] buttons are only
present when the determination has been loaded. With [EP details]
you can view details of the endpoints. This button is only available for
the titration modes DET, MET, SET and KFT. With [MP list] you can
open the list of measuring points of a titration, measurement or
monitored dosing.
List of measuring points
The list of measuring points is displayed in the dialog View data/MP
list.
Press [MP list]. This button is only available for titrations,
measurements and monitored dosing.
With the [Print] fixed key you can print out the complete list of
measuring points.
With [View] you can choose the quantities to be shown in the three
columns. The quantities that can be selected depend on the mode.
The settings are stored separately and system-specifically for each
mode.
Endpoint details
Additional data about the equivalence points or endpoints are
displayed in the dialog View data/EP details.
Press [EP details]. This button is only available for the titration
modes DET, MET, SET and KFT.