Metrohm 840 PC Control 5.0 / Touch Control - Manual (Page 333)

6 Appendix
PC Control / Touch Control
321
6.7 Import of Titrino methods (PC Control only)
With the Titrino method converter you can import Titrino methods into
the PC Control software.
Use the Metrohm VESUV software to save the methods which are
stored in the Titrino. The methods are stored in a .vmb file.
In the File menu open the menu item Import Methods...
Use [Open method] to open the Vesuv backup file dialog. Select
the required .vmb file and open it. The methods are listed under Se-
lect methods. If the methods have been stored in folders in the Ti-
trino then the folder will be shown in front of the method name and
separated from it by "/".
If you do not want to import all the methods in the backup file then
you can deactivate the checkboxes for these methods. With [Se-
lect none] or [Select all] you can select either none or all of the
methods in the list respectively.
Under Save method select the Memory and Group in which the con-
verted methods are to be stored. If the Autocorrection name func-
tion is switched on then invalid characters in method names will be
replaced by "_".
Start the conversion with [Convert method]. The conversion can
be stopped at any time with [Cancel].
Any messages produced during the conversion of the methods will be
shown under Report.