Metrohm 840 PC Control 5.0 / Touch Control - Manual (Page 175)

3 Operation
PC Control / Touch Control
163
3.22 Result silo
The result silo is ideal for providing a clear overview of the results
carried out, for example, on a particular day. You can store the results
of up to 200 determinations. A maximum of nine results from a single
determination can be stored in the result silo. As the display is not large
enough to show all the data at the same time, it is a good idea to print
out the result silo (see Section 3.23).
The results that are to be stored in the result silo are defined in the
CALC command (calculation).
In the Results dialog you can open the result silo with [Result silo].
The criterion according to which the results have been sorted is shown
above the list together with the number of determinations (of max. 200)
from which results have been stored in the result silo. If a filter has been
used then this number will normally be higher than the number of lines
shown. Each line corresponds to a determination.
The following details of the determination can be viewed with
[Details]:
• User who carried out the determination.
• Method with which the determinations was carried out.
• Determination time (date and time).
• Sample data (Identification 1 and 2, sample size).
• Results which have been calculated in the determination sequence
and stored in the result silo.
The selected determination line can be deleted from the result silo with
[Delete]. [Delete all] deletes all the lines.