Metrohm 840 PC Control 5.0 / Touch Control - Manual (Page 114)

3.14 Templates
102
PC Control / Touch Control
METER Mode C *********1000* switches ion meter to Conc measurement
METER Mode I *********0100* switches ion meter or pH meter to Ipol (mV
measurement) and starts it
METER Mode pH *********0001* switches ion meter or pH meter to pH measurement and
starts it
METER Mode T *********0010* switches ion meter or pH meter to temperature
measurement and starts it
METER Mode U *********0011* switches ion meter or pH meter to mV measurement and
starts it
Start device1 *************p starts device 1(e. g. Titrino, Titrando, ...) * )
Start device2 ********p***** starts device 2 (see above, only with multiple cable)* )
Start device* ********p****p starts devices 1 and 2 " *
)
Start Dos1 *******p****** starts Dosimat at device 1 (Titrino via "activate")
Start Dos2 *****p******** starts Dosimat at device 2 "
Start Dos* *****p*p****** starts Dosimat at devices 1 and 2 "
For START commands the signal is transmitted as a short impulse of 200 ms.
*
)
With pH meters or ion meters a result report is triggered
Use [Edit] to open the edit dialog for the template Continue.
You can also set pulses for the lines by entering a p in the binary
pattern. The pulse length is defined under Pulse length for "p". The
pulse length can only be entered for signals which are defined as
templates. If you define a signal directly in the CTRL command or in
manual operation then a fixed pulse length of 200 ms will be used. To
input the binary pattern please consult the online help.