Metrohm 840 PC Control 5.0 / Touch Control - Manual (Page 41)

3 Operation
PC Control / Touch Control
29
In a similar way to that used for methods, it is possible to state whether
a user is entitled to sign determinations at level 1, i.e. to Review
determinations, and/or is entitled to Release determinations, i.e. to
sign them at level 2. If Delete signatures has been activated for a
user then the user is entitled to delete signatures. As in the case of
methods, this is only possible when a determination has already been
signed at level 2.
Determinations can be signed under More determination
data/Properties. The procedure is described in Section 3.18.4.
Attention!
If you work with Login then User administration is only accessible
to users with administrator rights. This means that you must ensure
that at least two users have administrator rights so that one of them is
almost always available. Keep the rights of access for a user with
administrator rights in a safe place so that it is accessible in an
emergency.
3.7.6 Creating an identification card
If you have selected the version Login via identification card
under User administration/Login options (see Section 3.7.7) then
you must provide each user with an identification card. The
identification card has the User name and the current routine dialog
settings stored on it (see Section 3.7.4).
During login with an identification card a check is made that the user is
present in the list of users and whether expert dialog or routine dialog is
to be used. After a successful login the routine dialog settings stored on
the card are loaded into the system. These define the buttons and
functions that are accessible to the user if routine dialog is used.
If you wish to provide separate routine dialog settings for each user
then you must always adapt these settings (see Section 3.7.4) before
you create the identification card for the particular user. These user-
specific routine dialog settings are stored on the identification card
with the name of the user.
Touch Control
With Touch Control the identification card is always created in Card
slot 1 (13, see Fig. 2.2: Rear view of the Touch Control).
Insert the data card into Card slot 1.
In the user list, select the user for whom you would like to create the
identification card.
Press [Create ID card]. The settings are stored.
PC Control
Open the menu File/Preferences.
Define the drive in which the identification card is to be used under
Paths for Card 1 (see Section 3.11).