Metrohm 840 PC Control 5.0 / Touch Control - Manual (Page 191)

3 Operation
PC Control / Touch Control
179
3.24.2 Dosing
In the dialog Manual control/Dosing you can dose manually and
prepare or empty dosing devices. You can also check which dosing
devices are connected and which exchange or dosing units are
attached.
Select the [Dosing] function in the Manual control dialog. If
several dosing devices are connected to a control device then the
dialog for selecting a dosing device will be opened. If only one
dosing device is connected then the properties of this dosing
device will be shown directly:
For every dosing device the connection (MSB 1 to 4) and the type
are shown on the button. With type 8XX dosing devices with an
intelligent exchange unit or dosing unit the titrant will be shown to the
right. With type 6XX or 7XX dosing devices only the cylinder volume of
the exchange or dosing unit will be shown. If the exchange or dosing
unit is not (correctly) attached to a connected dosing device then "---"
will be shown. If a dosing device is busy with the determination
sequence then this will be indicated accordingly with "Manual busy".
With [All dosing devices] you can carry out the commands Fill,
Prepare and Empty for several dosing devices of a control device at
the same time.
Select the dosing device to be controlled manually.