Allied Telesis AT-S62 - Manual (Page 628)

Chapter 30: 802.1x Port-based Access Control
Section VI: Port Security 628
4. Configure the parameters as needed. Changes take affect
immediately on the switch. The parameters are defined below.
1 - Status
Activates and deactivate RADIUS accounting on the switch. Select
Enabled to activate the feature or Disabled to deactivate it. The
default is Disabled.
2 - Port
Specifies the UDP port for RADIUS accounting. The default is port
1813.
3 - Type
Specifies the type of RADIUS accounting. The default is Network. This
value cannot be changed.
4 - Trigger Type
Specifies the action that causes the switch to send accounting
information to the RADIUS server. The choices are:
❑ Start Stop - The switch sends accounting information whenever a
client logs on or logs off the network. This is the default.
❑ Stop only - The switch sends accounting information only when a
client logs off.
5 - Update Status
Controls whether the switch is to send interim accounting updates to
the RADIUS server. The default is disabled. If you enable this feature,
use the next option in the menu to specify the intervals at which the
switch is to send the accounting updates.
6 - Update Interval
Specifies the intervals at which the switch is to send interim
accounting updates to the RADIUS server. The range is 30 to 300
seconds. The default is 60 seconds.
5. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.