Allied Telesis AT-S62 - Manual (Page 337)

AT-S62 Menus Interface User’s Guide
Section II: Advanced Operations 337
Deleting an ARP
Entry
To delete an entry from the ARP table, perform the following procedure:
1. From the Main Menu, type 5 to select System Administration.
The System Administration menu is shown in Figure 7 on page 55.
2. From the System Administration menu, type 9 to select System
Utilities.
The System Utilities menu is shown in Figure 9 on page 61.
3. From the System Utilities menu, type 6 to select Networking Stack.
The Networking Stack menu is shown in Figure 118 on page 335.
4. From the Networking Stack menu, type 2 to select Delete ARP Entry.
The following prompt is displayed:
Enter IP address of the ARP entry to delete:
5. Enter the IP address of the entry you want to delete. You cannot
delete the first entry in the table with the interface designation
“loopback.”
The entry is immediately removed from the switch.
6. Repeat steps 4 and 5 to delete additional ARP table entries.
You do not need to return to the main menu to save the changes
made with this procedure.
Deleting All ARP
Entries
To delete all entries from the ARP table, perform the following
procedure:
1. From the Main Menu, type 5 to select System Administration.
The System Administration menu is shown in Figure 7 on page 55.
2. From the System Administration menu, type 9 to select System
Utilities.
The System Utilities menu is shown in Figure 9 on page 61.
3. From the System Utilities menu, type 6 to select Networking Stack.
The Networking Stack menu is shown in Figure 118 on page 335.
4. From the Networking Stack menu, type 3 to select Reset ARP Table.