Allied Telesis AT-S62 - Manual (Page 360)

Chapter 22: SNMPv3 Configuration
Section III: SNMPv3 Operations 360
Configuring the SNMPv3 User Table
This section contains a description of the SNMPv3 User Table and how to
create, delete, and modify table entries. Configure the SNMPv3 User
Table first. Creating this table, allows you to create an entry in an
SNMPv3 User Table for a User Name. In addition, this table allows you to
associate a User Name with the following parameters:
❑ Authentication Protocol
❑ Authentication Password
❑ Privacy Protocol
❑ Privacy Password
Note
You are prompted to configure the Privacy Protocol only if you are
using the encrypted version of the AT-S62 software.
There are three functions you can perform with the SNMPv3 User Table.
❑ Creating an SNMPv3 User Table Entry on page 360
❑ Deleting an SNMPv3 User Table Entry on page 364
❑ Modifying an SNMPv3 User Table Entry on page 364
Creating an
SNMPv3 User
Table Entry
To create an entry in the SNMPv3 User Table, perform the following
procedure:
1. From the Main Menu, type 5 to select System Administration.
The System Administration menu is shown in Figure 7 on page 55.
2. From the System Administration menu, type 5 to select SNMP
Configuration.
The SNMP Configuration menu is shown in Figure 16 on page 84.
3. From the SNMP Configuration menu, type 5 to select Configure
SNMPv3 Table.