Allied Telesis AT-S62 - Manual (Page 445)

AT-S62 Menus Interface User’s Guide
Section III: SNMPv3 Operations 445
Displaying SNMPv3 Table Menus
The procedures in this section describe how to display the SNMPv3
Tables. The following procedures are provided:
❑ Displaying the Display SNMPv3 User Table Menu on page 445
❑ Displaying the Display SNMPv3 View Table Menu on page 447
❑ Displaying the Display SNMPv3 Access Table Menu on page 448
❑ Displaying the Display SNMPv3 SecurityToGroup Table Menu on
page 449
❑ Displaying the Display SNMPv3 Notify Table Menu on page 450
❑ Displaying the Display SNMPv3 Target Address Table Menu on
page 451
❑ Displaying the Display SNMPv3 Target Parameters Table Menu on
page 452
❑ Displaying the Display SNMPv3 Community Table Menu on page
453
Displaying the
Display SNMPv3
User Table Menu
This section describes how to display the Display SNMPv3 User Table
Menu. For information about the SNMPv3 User Table, see Creating an
SNMPv3 User Table Entry on page 360.
To display the Display SNMPv3 User Table Menu, perform the following
procedure.
1. From the Main Menu, type 5 to select System Administration.
The System Administration menu is shown in Figure 7 on page 55.
2. From the System Administration menu, type 5 to select SNMP
Configuration.
The SNMP Configuration menu is shown in Figure 16 on page 84.
3. From the SNMP Configuration menu, type 5 to select Configure
SNMPv3 Table.
The Configure SNMP Menu is shown in Figure 127 on page 361.
4. From the Configure SNMP Menu, type 6 to select Display SNMPv3
Table.