Allied Telesis AT-S62 - Manual (Page 193)

AT-S62 Menus Interface User’s Guide
Section II: Advanced Operations 193
Downloading a
File from a Telnet
Management
Session
Review Guidelines on page 188 before performing this procedure.
To download a file onto a switch from a Telnet management session
using TFTP, perform the following procedure:
1. Establish a Telnet management session on the switch where you
want to download the file.
2. From the Main Menu, type 5 to select System Administration.
The System Administration menu is shown in Figure 7 on page 55.
3. From the System Administration menu, type 9 to select System
Utilities.
The System Utilities menu is shown in Figure 9 on page 61.
4. For the System Utilities menu, type 2 to select Downloads and
Uploads.
The Downloads and Uploads menu is shown in Figure 51 on page
177.
5. Type 3 to select Download a File.
The following prompt is displayed:
Only TFTP downloads are available for a Telnet
access
TFTP Server IP address:
6. Enter the IP address of the TFTP server.
The following prompt is displayed:
Remote File Name:
7. Enter the file name of the file on the TFTP server to download onto the
switch.
The following prompt is displayed:
Local File Name:
8. Enter a name for the file. The file is given this name when it is stored
in the switch’s file system. When naming a file, be sure to give it an
extension that corresponds to its file type. The extensions and file
types are listed in Table 2 on page 190.
The following message is displayed:
Getting the file from Remote TFTP Server - Please
wait ...
9. If you have not already done so, start the TFTP server software.