Allied Telesis AT-S62 - Manual (Page 379)

AT-S62 Menus Interface User’s Guide
Section III: SNMPv3 Operations 379
Configuring the SNMPv3 Access Table
This section contains a description of the SNMPv3 Access Table and how
to create, delete, and modify table entries. The SNMPv3 Access Table
allows you to configure a security group. Each user must belong to a
security group. After you have configured a security group, use the
SecurityToGroup Table to assign users to security groups. See Creating
an SNMPv3 SecurityToGroup Table Entry on page 394.
For each security group, you can assign the following attributes:
❑ a Security Model (SNMPv1, SNMPv2c, SNMPv3)
❑ Read, write, and notify views
❑ A security level
❑ A storage type
Before you begin this procedure, you will need to configure entries in
the View Table. These values are used to configure the Read, Write, and
Notify View parameters in this procedure. See Configuring the SNMPv3
View Table on page 370.
There are three functions you can perform with the SNMPv3 Access
Table.
❑ Creating an SNMPv3 Access Table Entry on page 379
❑ Deleting an SNMPv3 Access Table Entry on page 383
❑ Modifying an SNMPv3 Access Table Entry on page 385
Creating an
SNMPv3 Access
Table Entry
To create an entry in the SNMPv3 Access Table, perform the following
procedure.
1. Follow steps 1 through 3 in the procedure described in Creating an
SNMPv3 User Table Entry on page 360. Or, from the Main Menu type
5->5->5.
The Configure SNMPv3 Table Menu is shown in Figure 127 on
page 361.
2. From the Configure SNMPv3 Table Menu, type 4 to select Configure
SNMPv3 Access Table.