Allied Telesis AT-S62 - Manual (Page 475)

AT-S62 Menus Interface User’s Guide
Section IV: Spanning Tree Protocols 475
6 - Bridge Identifier
The MAC address of the bridge. The bridge identifier is used as a
tie breaker in the selection of the root bridge when two or more
bridges have the same bridge priority value. This value cannot be
changed.
3. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
Configuring
RSTP Port
Settings
To adjust RSTP port parameters, perform the following procedure:
1. From the Spanning Tree Configuration menu, type 3 to select STP
Configuration.
The STP Menu is shown in Figure 158 on page 468.
2. From the STP Menu, type P to select RSTP Port Parameters.
The RSTP Port Parameters menu is shown in Figure 163.
Figure 163 RSTP Port Parameters Menu
3. Type 1 to select Configure RSTP Port Settings.
The following prompt is displayed:
Starting Port to Configure [1 to 24] ->
4. Enter the number of the port you want to configure. To configure a
range of ports, enter the first port of the range.
The following prompt is displayed:
Ending Port to Configure [1 to 24] ->
5. To configure just one port, enter the same port number here as you
entered in the previous step. To configure a range of ports, enter the
last port of the range.
Allied Telesyn Ethernet Switch AT-8524M - AT-S62
Production Switch
User: Manager 11:20:02 02-Jan-2004
RSTP Port Parameters
1 - Configure RSTP Port Settings
2 - Display RSTP Port Configuration
3 - Display RSTP Port State
R - Return to Previous Menu
Enter your selection?