Allied Telesis AT-S62 - Manual (Page 343)

AT-S62 Menus Interface User’s Guide
Section II: Advanced Operations 343
The example in Figure 121 on page 341 shows that the Telnet and
web browser servers are active on the switch. The table also
includes two active TCP connections. Entry 4 is for a Telnet
connection and entry 24 is for a web browser HTTP connection.
A web browser management session can have more than one TCP
connection open at a time. The different connections carry
different packets of the management session.
You cannot change any of the information in this table. The only
operating parameter on the switch that affects management TCP
connections that you can adjust, other than enabling or disabling
the servers, is the TCP port used by the web browser server. The
default values are port 80 for HTTP and 443 for HTTPS. For
instructions on how to change this setting, refer to Configuring
the Web Server on page 634. The management software does not
allow you to change the default port number of 23 for Telnet
connections or 22 for SSH connections.