Allied Telesis AT-S62 - Manual (Page 181)

AT-S62 Menus Interface User’s Guide
Section II: Advanced Operations 181
Downloading an
AT-S62 Image
from a Telnet
Management
Session
Review the Guidelines on page 175 before performing the following
download procedure.
To download a new AT-S62 image onto the application block portion of
the switch’s flash memory, making it the active image file on the switch,
from a Telnet management session using TFTP, perform the following
procedure:
1. Establish a Telnet management session on the switch where you
want to download the new management software.
2. From the Main Menu, type 5 to select System Administration.
The System Administration menu is shown in Figure 7 on page 55.
3. From the System Administration menu, type 9 to select System
Utilities.
The System Utilities menu is shown in Figure 9 on page 61.
4. For the System Utilities menu, type 2 to select Downloads and
Uploads.
The Downloads and Uploads menu is shown in Figure 51 on page
177.
5. Type 1 to select Download Application Image/Bootloader.
The following prompt is displayed:
Only TFTP downloads are available for a Telnet
access
TFTP Server IP address:
6. Enter the IP address of the TFTP server.
The following prompt is displayed:
Remote File Name:
7. Enter the file name of the AT-S62 image file on the TFTP server to
download onto the switch. (Be sure to include the “.img” extension.)
The following message is displayed:
Getting the file from Remote TFTP Server - Please
wait ...
8. If you have not already done so, start the TFTP server software.
After downloading the image file, the switch displays the following
message:
File received successfully!