Allied Telesis AT-S62 - Manual (Page 426)

Chapter 22: SNMPv3 Configuration
Section III: SNMPv3 Operations 426
entry with a NonVolatile storage type, the S - Save Configuration
Changes option appears on the Main Menu, allowing you to save
your changes.
Note
The Row Status parameter is a read-only field in the Telnet and Local
interfaces. The Active value indicates the SNMPv3 Target
Parameters Table entry will take effect immediately.
9. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
Deleting an
SNMPv3 Target
Parameters Table
Entry
You may want to delete an entry from the SNMPv3 Target Parameters
Table. When you delete an SNMPv3 Target Parameters Table entry, there
is no way to undelete, or recover, it.
To delete an entry in the SNMPv3 Target Parameters Table, perform the
following procedure:
1. Follow steps 1 through 3 in the procedure described in Creating an
SNMPv3 User Table Entry on page 360. Or, from the Main Menu type
5->5->5.
The Configure SNMPv3 Table Menu is shown in Figure 127 on
page 361.
2. From the Configure SNMPv3 Table Menu, type 8 to select Configure
SNMPv3 Target Parameters Table.
The Configure SNMPv3 Parameters Table Menu is shown in Figure
140 on page 423.
Note
To display a Group Name and its associated parameters from the
Configure SNMPv3 SecurityToGroup Table Menu, type N to display
the Next Page and P to display the previous page.
3. To delete an SNMPv3 Target Parameters Table entry, type 2 to select
Delete SNMPv3 Table Entry.
The following prompt is displayed:
Enter Target Parameters Name:
4. Enter a Target Parameters Name.
The following prompt is displayed:
Do you want to delete this table entry? (Y/N):
[Yes/No]->