Allied Telesis AT-S62 - Manual (Page 190)

Chapter 12: File Downloads and Uploads
Section II: Advanced Operations 190
The following prompt is displayed:
Remote File Name:
c. Enter the file name of the file on the TFTP server to download to
the switch. You can specify only one file.
The following prompt is displayed:
Local File Name:
d. Enter a name for the file. The file is given this name when it is
stored in the switch’s file system. When naming a file, be sure to
give it an extension that corresponds to its file type. The
extensions and file types are listed in Table 2.
The following message is displayed:
Getting the file from Remote TFTP Server - Please
wait ...
e. If you have not already done so, start the TFTP server software.
After downloading the system file, the switch displays the
following message:
File received successfully!
This completes the process for downloading a file using TFTP.
f. If you downloaded a new configuration file and you want to make
it the switch’s active boot file, go to Setting the Active Boot
Configuration File on page 166. If you downloaded a CA certificate
and need to add it to the certificate database, refer to Adding a
Certificate to the Database on page 672.
7. To download a file using Xmodem, type X at the prompt displayed in
Step 5.
The following prompt is displayed:
Local File Name:
Table 2 File Name Extensions
Extension File Type
.cfg Configuration file
.cer Certificate file
.img AT-S62 image file