Allied Telesis AT-S62 - Manual (Page 117)

AT-S62 Menus Interface User’s Guide
Section I: Basic Operations 117
Deleting Unicast and Multicast MAC Addresses
To delete a dynamic or static unicast or multicast address from the MAC
address table, perform the following procedure:
1. From the Main Menu, type 4 to select MAC Address Tables.
The MAC Address Tables menu is shown in Figure 27 on page 111.
2. From the MAC Address Tables menu, type 2 to select Configure MAC
Addresses.
The Configure MAC Addresses menu is shown in Figure 31 on
page 115.
3. From the Configure MAC Addresses menu, type 2 to select Delete
MAC Address.
The following prompt is displayed:
Please enter a MAC address ->
4. Enter the unicast or multicast MAC address to be deleted in either of
the following formats:
XXXXXXXXXXXX or XXXXXX XXXXXX
After you have entered the MAC address, the following prompt is
displayed:
Please enter VLAN ID -> [1 to 4094] -> 1
5. Enter the VLAN ID of the port where the address was assigned or
learned.
The MAC address is deleted from the switch’s MAC address table.
Note
You cannot delete a switch’s MAC address, an STP BPDU MAC
address, or a broadcast address.
6. Repeat the procedure to delete additional MAC addresses.
7. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.