Allied Telesis AT-S62 - Manual (Page 545)

AT-S62 Menus Interface User’s Guide
Section V: Virtual LANs 545
Activating or deactivating ingress filtering has no effect on the switch’s
handling of priority tags. A switch will always examines a priority tag in a
tagged frame, without regard to the status of ingress filtering.
You can enable or disable ingress filtering on a per switch basis. You
cannot set this per port. The default setting for ingress filtering is
disabled.
To enable or disable ingress filtering, perform the following procedure:
1. From the Main Menu, type 2 to select VLAN Configuration.
The VLAN Configuration menu is shown in Figure 182 on page 528.
2. From the VLAN Configuration menu, type 1 to select Ingress Filtering
Status.
The following prompt is displayed:
Enter Ingress Filtering Status (E-Enable, D-
Disable) ->
3. Type E to activate ingress filtering or D to disable the feature on the
switch.
A change to the status of ingress filtering is immediately activated on
the switch.
4. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.