Allied Telesis AT-S62 - Manual (Page 210)

Chapter 13: Event Log
Section II: Advanced Operations 210
Enter new log full action (1-Wrap on Full, 2-Halt on Full)
->
6. Type 1 if you want the switch to delete the oldest entries as it adds
new entries, or 2 if the switch is to stop adding entries when the log
reaches maximum capacity.
7. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
Saving the Event
Log
The Event Log menu has the selection “S - Save Log to File” for saving the
current contents of the log as a file in the file system. Once in the file
system, you can either view it or download it to your management
workstation.
Before selecting the option, configure options 2 to 7 in the Event Log
menu to specify which log entries you want to save. When you select the
option, you are asked to specify a filename. The name can be up to 16
alphanumeric characters, followed by the extension “.log”.
For instructions on the AT-S62 file system, refer to Chapter 11, File
System.
Clearing the
Event Log
To clear all events from the log, perform the following procedure:
1. From the Main menu, type 5 to select System Administration.
2. From the System Administration menu, type 8 to select Event Log.
The Event Log menu is shown in Figure 60 on page 204.
3. Type C to select Clear Log.
A confirmation prompt is displayed,
4. Type Y to clear the log or N to cancel the procedure.
The log, if enabled, immediately begins to learn new events.