Allied Telesis AT-S62 - Manual (Page 326)

Chapter 20: Power Over Ethernet
Section II: Advanced Operations 326
6. To change the port’s priority, type 2 to select Power Priority and,
when prompted, type C for Critical, H for High, or L for Low. A port can
belong to only one priority level at a time. The default is Low. For an
explanation of this parameter, refer to Port Prioritization on page 321.
7. To change the maximum amount of power the port can supply to the
device, type 3 to select Power Limit and enter a new value in
milliwatts. The default value is 15,400 mW.
A change to a parameter value is immediately activated on the
switch.
8. After making your changes, type R until you return to the Main Menu.
Then type S to select Save Configuration Changes.