Allied Telesis AT-S62 - Manual (Page 205)

AT-S62 Menus Interface User’s Guide
Section II: Advanced Operations 205
3- Display Order
Controls the order of the events in the log. Choices are
Chronological, which displays the events in the order oldest to
newest, and Reverse Chronological, which displays the events
newest to oldest. The default is Chronological.
4 - Display Mode
Controls the format of the event log. Choices are Normal, which
displays the time, module, severity, and description for each
event, and Full, which displays the same information as Normal,
plus filename, line number, and event ID. The default is Normal.
For an example of the display and definitions of the information,
refer to Figure 61 on page 208.
5 - Display Severity
Displays events of a selected severity. Event severity is a
predefined value assigned to an event according to its potential
impact on switch operation. There are four severity levels, as
defined in Table 3. The default is informational, error, and
warning. You can specify more than one severity (for example,
E,W).
6 - Display Module
Displays events of a selected AT-S62 module. The AT-S62
management software consists of a number of modules, each
responsible for a different part of switch operation. You can
Table 3 Event Log Severity Levels
Value Severity Level Description
ALL - Selects all severity levels
E Error Switch operation is severely impaired.
W Warning An issue may require manager attention.
I Information Useful information that can be ignored
during normal operation.
D Debug Messages intended for Technical Support
and Software Development.