Allied Telesis AT-S62 - Manual (Page 216)

Chapter 13: Event Log
Section II: Advanced Operations 216
The switch immediately begins to send events to the server, if you
enabled the definition when you created it, and adds the new
syslog server definition to the Configure Log Outputs menu. An
example of the menu with a syslog server definition is shown in
Figure 64.
Figure 64 Configure Log Outputs Menu with a Syslog Server Definition
8. Repeat this procedure starting with step 4 to create additional syslog
server definitions, if needed.
9. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
Modifying a
Syslog Server
Definition
To modify a syslog server definition, perform the following procedure:
1. From the Main Menu, type 5 to select System Administration.
2. From the System Administration menu, type 8 to select Event Log.
The Event Log menu is shown in Figure 60 on page 204.
3. From the Event Log menu, type L to select Configure Log Outputs.
The Configure Log Outputs menu is shown in Figure 62 on page
209.
4. Type 2 to select Modify Log Output.
The following prompt is displayed:
Enter output ID to modify [1 to 20] -> 1
5. Enter the ID number of the syslog server definition you want to
modify.
Allied Telesyn Ethernet Switch AT-8524M - AT-S62
Production Switch
User: Manager 11:20:02 02-Jan-2004
Configure Log Outputs
OutputID Type Status Details
-----------------------------------------------------------
1
Temporary Enabled Wrap on Full
2 Syslog Enabled 149.44.44.44
1 - Create Log Output
2 - Modify Log Output
3 - Delete Log Output
4 - View Log Output Details
R - Return to Previous Menu
Enter your selection?