Allied Telesis AT-S62 - Manual (Page 625)

AT-S62 Menus Interface User’s Guide
Section VI: Port Security 625
The Configure Supplicant Port Access Parameters menu is shown in
Figure 222.
Figure 224 Configure Supplicant Port Access Parameters Menu
6. Select the parameter that you want to modify. The parameters are
described below:
1 - Auth Period
Specifies the period of time in seconds that the supplicant will wait for
a reply from the authenticator after sending an EAP-Response frame.
The range is 1 to 60 seconds. The default is 30 seconds.
2 - Held Period
Specifies the amount of time in seconds the supplicant is to refrain
from retrying to re-contact the authenticator in the event the end
user provides an invalid username and/or password. Once the time
period has expired, the supplicant can attempt to log on again. The
range is 0 to 65,535 seconds. The default value is 60.
3 - Max Start
Specifies the maximum number of times the supplicant will send
EAPOL-Start frames before assuming that there is no authenticator
present. The range is 1 to 10. The default is 3.
4 - Start Period
Specifies the time period in seconds between successive attempts by
the supplicant to establish contact with an authenticator when there
is no reply. The range is 1 to 60. The default is 30.
5 - User Name
Specifies the username for the port. The port sends the name to the
authentication server for verification when the port logs on to the
Allied Telesyn Ethernet Switch AT-8524M - AT-S62
Production Switch
User: Manager 11:20:02 02-Jan-2004
Configure Supplicant Port Access Parameters
Configuring Port 5-8
1 - Auth Period........... 30 Seconds
2 - Held Period........... 60 Seconds
3 - Max Start............. 3
4 - Start Period.......... 30 Seconds
5 - User Name.............
6 - User Password.........
R - Return to Previous Menu
Enter your selection?