Allied Telesis AT-S62 - Manual (Page 272)

Chapter 16: Quality of Service
Section II: Advanced Operations 272
The Flow Group Configuration menu is shown in Figure 88 on
page 270.
4. Type 2 to select Modify Flow Group.
The following prompt is displayed:
Available Flow Group(s): 0-10
Enter Flow Group ID : [0 to 1023] -> 0
5. Enter the ID number of the flow group you want to modify. You can
modify only one flow group at a time.
The Modify Flow Group menu is displayed. The menu contains the
specifications of the selected flow group.
6. Modify the settings as needed. For parameter definitions, refer to
Creating a Flow Group on page 269.
When modifying a flow group, note the following:
❑ You cannot change a flow group’s ID number.
❑ To delete a value from a variable so as to leave it blank, select the
variable and then use the backspace key to delete its default
value.
❑ Specifying an invalid value for a parameter that already has a
value causes the parameter to revert to its default value.
7. After you have finished modifying the parameter settings, type M to
select Modify Flow Group.
8. To modify another flow group, repeat this procedure starting with
step 4. To assign the flow group to a traffic class, go to Managing
Traffic Classes on page 275.
9. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
Deleting a Flow
Group
To delete a flow group, do the following procedure:
1. From the Main Menu, type 7 to select Security and Services.
2. From the Security and Services menu, type 6 to select Quality of
Service.
The Quality of Service (QoS) menu is shown in Figure 87 on page
269.
3. From the Quality of Service (QoS) menu, type 1 to select Flow Group
Configuration.
The Flow Group Configuration menu is shown in Figure 88 on
page 270.