Allied Telesis AT-S62 - Manual (Page 189)

AT-S62 Menus Interface User’s Guide
Section II: Advanced Operations 189
These guidelines apply to a TFTP download:
❑ Your network must have a node with TFTP server software.
❑ The file to be downloaded must be stored on the TFTP server.
❑ You should start the TFTP server software before you begin the
download procedure.
❑ The switch where you are downloading the file must have an IP
address and subnet mask, such as a master switch of an enhanced
stack. For switches without an IP address, such as slave switches,
you can download the file from a local management session of the
switch using Xmodem.
Downloading a
File from a Local
Management
Session
Review Guidelines on page 188 before performing this procedure.
To download a file onto a switch from a local management session using
Xmodem or TFTP, perform the following procedure:
1. Establish a local management session on the switch where you want
to download the system file.
2. From the Main Menu, type 5 to select System Administration.
The System Administration menu is shown in Figure 7 on page 55.
3. From the System Administration menu, type 9 to select System
Utilities.
The System Utilities menu is shown in Figure 9 on page 61.
4. For the System Utilities menu, type 2 to select Downloads and
Uploads.
The Downloads and Uploads menu is shown in Figure 51 on page
177.
5. Type 3 to select Download a File.
The following prompt is displayed:
Download Method/Protocol [X-Xmodem, T-TFTP]:
6. To download a system file using Xmodem, go to Step 7. To download
a file using TFTP, do the following:
a. Type T.
The following prompt is displayed:
TFTP Server IP address:
b. Enter the IP address of the TFTP server.