Allied Telesis AT-S62 - Manual (Page 501)

AT-S62 Menus Interface User’s Guide
Section IV: Spanning Tree Protocols 501
2. Enter the ID number of the MSTI you want to delete. The range is 1 to
15. (You cannot delete CIST, which has a value of 0.) You can delete
only one MSTI at a time.
The selected MSTI is deleted from the switch. All associated VLANs
are returned to CIST.
3. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
Modifying an
MSTI
To change the priority value of an MSTI or the associated VLANs, do the
following:
1. From the MSTI Menu, type 3 to select MSTI Configuration Menu.
The following prompt is displayed:
Enter the MSTI ID to be modified: [1 to 15] ->
2. Enter the ID number of the MSTI you want to modify. The range is 1 to
15. You can modify only one MSTI at a time.
The following prompt is displayed:
Enter new priority [the value will be multiplied by
4096] [0 to 15] -> 8
3. Enter a new MSTI priority number. This parameter is used in selecting
a regional root. The range is 0 (zero) to 61,440 in increments of 4,096,
with 0 being the highest priority. The default is increment 8 for a value
of 32768. For a list of the increments, refer to Table 10, Bridge Priority
Value Increments on page 457.
The following prompt is displayed:
Enter the list of VLANs to associate with this MSTI:
4. Enter the VIDs of the VLANs you want to associate with this MSTI. You
can specify more than one VLAN at a time (for example, 4,6,11). The
new VLAN associates overwrite the current VLAN associations. To add
new VLANs while retaining the existing VLAN associations, you must
enter the VIDs of the new and existing VLANs. To remove VLAN
associations, reenter the VLAN ID list, omitting the VIDs of those
VLANs you no longer want associated with the MSTI. If you do not
want to change the current associates, just press Return. To view the
VIDs of the VLANs on the switch, refer to Displaying VLANs on page
538.
The MSTI modifications are immediately activated on the switch.
5. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.