Allied Telesis AT-S62 - Manual (Page 374)

Chapter 22: SNMPv3 Configuration
Section III: SNMPv3 Operations 374
Modifying an
SNMPv3 View
Table Entry
This section describes how to modify parameters in an SNMPv3 Notify
Table entry. See the following procedures:
❑ Modifying a Subtree Mask on page 374
❑ Modifying a View Type on page 376
❑ Modifying a Storage Type on page 377
Modifying a Subtree Mask
To modify the Subtree Mask parameter in an SNMPv3 View Table entry,
perform the following procedure.
1. Follow steps 1 through 3 in the procedure described in Creating an
SNMPv3 User Table Entry on page 360. Or, from the Main Menu type
5->5->5.
The Configure SNMPv3 Table Menu is shown in Figure 127 on
page 361.
2. From the Configure SNMPv3 Table Menu, type 3 to select Configure
SNMPv3 View Table.
The Configure SNMPv3 View Table Menu is shown in Figure 130
on page 371.
3. From the Configure SNMPv3 View Table Menu, type 3 to select
Modify SNMPv3 Table Entry.