Allied Telesis AT-S62 - Manual (Page 39)

AT-S62 Menus Interface User’s Guide
Section I: Basic Operations 39
4. When prompted, enter a username and password.
To configure the switch settings, enter “manager” as the user
name. The default password for manager access is “friend”. To just
view the settings, enter “operator” as the user name. The default
password for operator access is “operator”. Usernames and
passwords are case-sensitive. For information on the two access
levels, refer to Management Access Levels on page 34. (For
instructions on how to change a password, refer to Configuring
the Manager and Operator Passwords on page 62.)
After logging on, you will see the window in Figure 2. This is the
command prompt interface. You will see either a “#” symbol if you
logged on as a manager or a “$” symbol if you logged on as an
operator.
Figure 2 Command Prompt
For instructions on how to use the command line interface, refer
to the AT-S62 Command Line User’s Guide, which is available from
the Allied Telesyn web site.
5. To use the menu interface, type menu at the command prompt.
The Main Menu is shown in Figure 3.
Figure 3 Main Menu
Allied Telesyn Ethernet Switch AT-8524M - AT-S62
#
Allied Telesyn Ethernet Switch AT-8524M - AT-S62
User: Manager 11:20:02 02-Jan-2004
Main Menu
1 - Port Configuration
2 - VLAN Configuration
3 - Spanning Tree Configuration
4 - MAC Address Tables
5 - System Administration
6 - Advanced Configuration
7 - Security and Services
8 - Enhanced Stacking
C - Command Line Interface
Q - Quit
Enter your selection?