Allied Telesis AT-S62 - Manual (Page 147)

AT-S62 Menus Interface User’s Guide
Section I: Basic Operations 147
The LACP (IEEE 8023ad) Configuration menu is shown in Figure 39 on
page 140.
4. Type 4 to select Modify Aggregator.
The Modify LACP (IEEE 8023ad) Aggregator menu is shown in Figure
41.
Figure 42 Modify LACP (IEEE 8023ad) Aggregator Menu
5. Type 1 to select Port Number and, when prompted, enter the port
you want to configure. You can configure only one port at a time.
The management software displays the port’s current aggregator
settings. If the port is not a member of any aggregator, the
parameters still display default values that are specific to the port and
switch.
6. To set the port’s priority value, type 3 to Priority and enter the new
value in hexadecimal. The range is 1 to FFFF. The default is the port
number in hexadecimal.
7. To move the port to a different aggregator or to assign it to an
aggregator if it is not currently a member of one, type either 2 to
select Adminkey or 4 to select Aggregator and enter the adminkey
value or name of the aggregator where you want to assign the port.
You can specify only one aggregator and it must already exist on the
switch.
8. Type M to select Modify Port.
Allied Telesyn Ethernet Switch AT-8524M - AT-S62
Production Switch
User: Manager 11:20:02 02-Jan-2004
LACP (IEEE 802.3ad) Port Configuration
1 - Port Number ................. 0
2 - Adminkey .................... 0x0000
3 - Priority .................... 0x0000
4 - Aggregator ..................
M - Modify Port
R - Return to Previous Menu
Enter your selection?