Allied Telesis AT-S62 - Manual (Page 285)

AT-S62 Menus Interface User’s Guide
Section II: Advanced Operations 285
4. From the Policy Configuration menu, type 2 to select Modify Policy.
The following prompt is displayed:
Available Policy(ies): 0-4
Enter Policy ID : [0 to 255] -> 0
5. Enter the ID number of the policy you want to modify. You can modify
only one policy at a time.
The Modify Policy menu is displayed. The menu contains the
specifications of the selected policy.
6. Modify the settings as needed. For parameter definitions, refer to
Creating a Policy on page 282.
When modifying a policy, note the following:
❑ You cannot change a traffic class’ ID number.
❑ To delete a value from a variable so as to leave it blank, select the
variable and then use the backspace key to delete its default
value.
❑ Specifying an invalid value for a parameter that already has a
value causes the parameter to revert to its default value.
7. After you have finished modifying the parameter settings, type M to
select Modify Policy.
Modifications to a policy are immediately activated on the ports
where the policy is assigned.
8. To modify another policy, repeat this procedure starting with step 4.
9. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
Deleting a Policy
To delete a policy, do the following procedure:
1. From the Main Menu, type 7 to select Security and Services.
2. From the Security and Services menu, type 6 to select Quality of
Service.
The Quality of Service (QoS) menu is shown in Figure 87 on page
269.
3. From the Quality of Service (QoS) menu, type 3 to select Policy
Configuration.
The Policy Configuration menu is shown in Figure 94 on page 282.
4. Type 3 to select Destroy Policy.
The following prompt is displayed: