Allied Telesis AT-S62 - Manual (Page 143)

AT-S62 Menus Interface User’s Guide
Section I: Basic Operations 143
4 - Port Range
Specifies the aggregator ports. An aggregator can contain any
number of ports on the switch. You can identify the ports individually
(for example, 3,7,10), as a range (for example, 5-11), or both (for
example, 2,4,11-14).
6. After you configure the parameters, type C to select Create
Aggregator.
The aggregator is created on the switch.
7. If LACP is not enabled on the switch, perform the procedure Enabling
or Disabling LACP on page 139 and activate the protocol.
8. Configure LACP on the other network device.
9. Connect the cables to the ports of the aggregator on both the switch
and the other network device.
The aggregator and its aggregate trunk(s) are now ready for network
operations.
Caution
Do not connect the cables to the ports of the aggregator on the
switch until after you have enabled LACP. Connecting the cables
before activating the protocol will create a loop in your network
topology. Data loops can result in broadcast storms and poor
network performance.
10. Repeat this procedure to create additional aggregators, if needed.
11. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
Modifying an
Aggregator
This procedure explains how to modify an aggregator. You can change
an aggregator’s name, adminkey, or load distribution method. You can
also use this procedure to add or remove ports. To modify an
aggregator, you need to know its name or adminkey key. It is
recommended that you review the section LACP Trunk Guidelines on
page 129 before modifying an aggregator.
Caution
If you will be adding or removing ports from the aggregator, you
should disconnect all network cables from the ports of the
aggregator on the switch before performing the procedure. Adding
or removing ports without first disconnecting the cables can result
in loops in your network topology, which can result in broadcast
storms and poor network performance.