Allied Telesis AT-S62 - Manual (Page 217)

AT-S62 Menus Interface User’s Guide
Section II: Advanced Operations 217
The Syslog Server Configuration menu is shown in Figure 63 on
page 212. The menu contains the specifications of the selected
definition.
6. Modify the settings as needed.
For definitions of the parameters, refer to Creating a Syslog Server
Definition on page 212. You cannot change a definition’s output
ID number.
7. When you are finished modifying the settings, type M to select
Modify Log Output.
The Configure Log Outputs menu is displayed again.
8. To modify additional definitions, repeat this procedure starting with
step 4.
9. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
Deleting a Syslog
Server Definition
To delete a syslog server definition, perform the following procedure:
1. From the Main Menu, type 5 to select System Administration.
2. From the System Administration menu, type 8 to select Event Log.
The Event Log menu is shown in Figure 60 on page 204.
3. From the Event Log menu, type L to select Configure Log Outputs.
The Configure Log Outputs menu is shown in Figure 62 on page
209.
4. Type 3 to select Delete Log Output.
The following prompt is displayed:
Enter output ID to delete [2 to 20] -> 2
5. Enter the ID number of the syslog server definition you want to
modify. You can enter only one ID number at a time.
The following confirmation prompt is displayed:
Are you sure you want to delete output ID 2? [Yes/No] ->
6. Type Y to delete the definition or N for no to cancel the procedure.
The definition is deleted from the Configure Log Outputs menu.
7. To delete additional definitions, repeat this procedure starting with
step 4.
8. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.