Setting the operation mode of the [all, Button in the transition control block, Setting the operation mode of the [cut – Sony GP-X1EM Grip Extension User Manual

Page 433

433

Continue:

Continue the auto transition.

Cancel:

Cancel the auto transition, and return to the

previous state.

Setting the transition indicator display in non-
sync state

In the group, select one of the
following.

Normal:

The transition indicator is lit when in non-sync

state.

Blink:

The transition indicator is blinking when in non-

sync state.

Setting the button display state when executing
an auto transition using the [AUTO TRANS]
button

In the group, select one
of the following.

Disable:

Lit amber during transition execution, and goes

off at the end of the transition.

Enable:

Lit green during transition execution, and at the

end of the transition it is lit red if on-air or lit amber if
not on-air.

Enable using the [AUTO TRANS] button in the
independent key transition execution section on the
transition control block, independent key transition control
block, or key fader control block.

Setting the [TRANS PVW] button operation mode

In the group, select one of the following.

Hold:

Enables transition preview mode only while the

[TRANS PVW] button is pressed.

Lock:

Pressing the [TRANS PVW] button switches

between transition preview mode and normal mode
each time the button is pressed.

The one-time mode setting is set in the Engineering Setup
>Switcher >Transition menu (7334)

(see page 469)

Setting the [KEY] button operation mode when a
key source bus is selected

In the group, select one of
the following.

Key:

The [KEY] button is always lit, and only key signals

are selected using the cross-point buttons.

Video & Key:

Enables key signals or video signals to be

selected using cross-point buttons, according to the
[KEY] button operation.

For details about the [KEY] button operation, see “To
select a video signal assigned to a cross-point button”
(page 113).

Setting the [UTIL] button operation mode

In the group, select one of the following.

Hold:

Enables utility bus mode only while the [UTIL]

button is pressed.

Lock:

Pressing the [UTIL] button switches between utility

bus mode and normal mode each time the button is
pressed.

Exchanging the [AUTO TRANS] button and [CUT]
button in the transition control block

Press [Auto Trans/Cut Swap], turning it on.

Setting the Operation Mode of the
[ALL] Button in the Transition
Control Block

This sets the next transition selected by the [ALL] button
in the transition control block.

In the Engineering Setup >Panel >Operation >Custom
Button/Fader menu (7326.4), press [Next Trans All].

The Next Trans All menu (7326.11) appears.

In the group, select the button for the
next transition.

If all next transition buttons are disabled, the next
transition cannot be set even if the [ALL] button is
pressed.

Setting the Operation Mode of the
[CUT] Button in the Transition
Control Block

You can prevent the double-press function action of the
[CUT] button on the transition control block or transition
control block (simple type).
When the double-press prevention function is enabled,
only a single cut operation is executed if the [CUT] button
is pressed twice within the configured time interval.

In the Engineering Setup >Panel >Operation menu
(7326), press [Sensitivity].

The Sensitivity menu (7326.5) appears.

Press [Enable] in the
group.

To disable the double-press prevention function, press
[Disable].

Set the following parameter to set the double-press
interval.

Note