Setting flexi pad control block button, Display and operation, Setting the button and fader lever operation – Sony GP-X1EM Grip Extension User Manual

Page 432: Mode, Setting the button and fader lever operation mode

432

name set on the router or an NS-Bus alias name set on the
system controller.
The source name is updated each time the description
name/alias name is updated. This allows you to always use
the same name between the router/system controller and
the switcher.
The S-Bus description name/NS-Bus alias name is
reflected in the source name setting in the Xpt Assign
menu, hence the name set on the router/system controller
is also displayed when [Sw’er Local] is selected in the
group.

To enable the link function for S-Bus

In the Engineering Setup >Panel >Operation menu (7326),
press [S-Bus Name Link], turning it on.

To enable the link function for NS-Bus

In the Engineering Setup >Panel >Operation menu (7326),
press [NS-Bus Name Link], check the message, then press
[Yes].

• When [NS-Bus Name Link] is enabled, the settings of all

source names for the switcher (including wiring
traceback), not just in the Xpt Assign menu, are always
replaced by the NS-Bus alias name.

• To display the NS-Bus alias name on a multi viewer sub

screen, you must select [NS-Bus Alias] in the Dest Name> group and enable [NS-Bus Name Link].

Setting Flexi Pad Control Block
Button Display and Operation

In the Engineering Setup >Panel >Operation menu (7326),
press [Flexi Pad Mode] to open the Flexi Pad Mode menu
(7326.3).
Configure each function, as required.

Linking the transition type selection with the
Flexi Pad control block operation mode

Press [Wipe/DME Auto Deleg], turning it on.
This switches the operation mode of the Flexi Pad control
block in sync with the selection of the [WIPE] button or
[DME WIPE] button on the transition control block.

Setting the memory recall button display in wipe
snapshot operation mode and DME wipe
snapshot operation mode

In the group, select one of the
following.

Pattern:

Pattern image display

Register Name:

Setting the memory recall button display in
snapshot operation mode and effect operation
mode

In the group, select one of the
following.

Register No.:

Register Name:

Assigning a register to bottom left button of bank
0

In the group, select one of the
following.

Register Assign:

Assign a register. Select the register

number using the following parameter.

a) 1 to 99 configurable only

Register No Assign:

Disable register assignment.

The bottom left button of bank 0 cannot be selected in the
Misc >Snapshot menu on each switcher bank.

Setting the Button and Fader Lever
Operation Mode

In the Engineering Setup >Panel >Operation menu (7326),
press [Custom Button/Fader] to open the Custom Button/
Fader menu (7326.4).
Configure each function, as required.

Setting the double-press operation mode of the
[BKGD] button in the transition control block

In the group, select one of
the following.

Disable:

Double-pressing of the [BKGD] button is

disabled.

Enable:

When the [BKGD] button is pressed twice in

quick succession, all currently inserted keys are
selected and removed by the next transition.

Setting the operation mode when the [FTB]
button is pressed during fade-to-black

In the group, select one of the following.

Continue:

Continue the fade-to-black.

Cancel:

Cancel the fade-to-black, and return to the

previous state.

Setting the operation mode when the [AUTO
TRANS] button or [TAKE] button is pressed
during an auto transition

In the group, select one of the
following.

Notes

No.

Parameter

Adjustment

Note