Metrohm 726 Titroprocessor - Manual (Page 80)

5.2 Method editor
726 Titroprocessor, Instructions for use 74 74
[* Param]
Titration and measuring modes have extended sets of
parameters for setting control parameters, etc. These are
accessed via this softkey. Descriptions of each setting
can be found under command references, page 127ff.
[*Formula]
Titration and measuring modes allow different calculation
formulas valid for the particular mode to be used. The
formula editor is described in section 7.10 (Titration and
measuring modes), page 118ff.
[* Report]
Titration and measuring modes can contain various report
blocks which only apply to that particular mode. These
mode reports form individual parts of the full report and
appear between the introductory (start) determination
report and the concluding (end) determination report. A
description of the report editor is given in section 7.11
(Titration and measuring modes), page 123ff.
[Insert
line]
inserts an empty command line in front of the current line.
[Delete
deletes the current command line. The field cursor must
line]
be in the command column.
[ >> >>]
shows the second softkey bar.
[Copy
copies the current command line in into a local
line]
buffer.
[Cut
copies the marked command into a local buffer
line]
and deletes the current command line.
[Paste
takes the copied command from the local buffer
line]
and inserts it in front of the current command line.
[ >> >>]
shows the first softkey bar.
5.2.4 Determination report
Determination report blocks can be defined as parts of the full report; they
can either be produced at the start of a determination or at the end of a
determination. In addition, reports can be defined which are produced at the
end of a determination when the capacity of the statistics counter is
reached.
Determination reports cannot only be printed out but can also be transferred
directly to a PC database such as the Metrohm software VESUV 3.