Metrohm 726 Titroprocessor - Manual (Page 204)

8.12 CASE sequences
726 Titroprocessor, Instructions for use 198 198
Example of a method with interlaced CASE:
In this case a simple check of the sample weight is made before the titration
itself and the result assessed after the titration.
Command Parameters Parameters
ДДДДДДДДДДДДД ДДДДДДДДДДДДДДДДДДДДДДДД ДДДДДДДДДДДДДДДДДДДДДДДД
ASK Ident. item all Size confirm.
(CASE SS>1.0
WAIT Sample size too large
CASE SS>=0.5
SHOW Page Curve
DET_PH* Assay
Reagent Sensor
Concentr. Meas. input A1
Dos. drive A1
(CASE R1<90 OR EF1=0
WAIT Result too low or no EP
WAIT Repeat the determination!
)CASE
SHOW Page Main
CASE SS<0.5
WAIT Sample size too small
)CASE
END
Example of a method remote interface query
In this case an input signal on input line 0 is waited for before a titration is
started. If a further input line receives an active signal then an error state will
be assumed and the determination terminated without a titration.
Command Parameters Parameters
ДДДДДДДДДДДДД ДДДДДДДДДДДДДДДДДДДДДДДД ДДДДДДДДДДДДДДДДДДДДДДДД
SCAN_RM Remote A Pattern *******1
(CASE StateA<>0000000*
WAIT An error ocurred!
CASE StateA=00000001
DET_PH* Sample titration
Reagent Sensor
Concentr. Meas. input A1
Dos. drive A1
)CASE
END