Metrohm 726 Titroprocessor - Manual (Page 35)

22. . Installation Installation
726 Titroprocessor, Instructions for use 29 29
The following table shows the settings and cables needed to connect print-
ers to one of the serial interfaces.
Printer Cable RS232 settings Printer settings
IBM Proprinter
or
compatibles
6.2125.050 Baud rate: 9600
Data bit: 8
Stop bit: 1
Parity: none
Handshake: HWshort
Printer: IBM Propr.
see printer manual
Epson
with 6-pole
round plug
6.2125.040 Baud rate: 9600
Data bit: 8
Stop bit: 1
Parity: none
Handshake: HWshort
Printer: Epson 80x60
DIP switch settings:
SW1 SW2
on
off
1 2 3 4 5 6 7 8 1 2 3 4 5 6 7 8
Epson LX-300 6.2125.050 Baud rate: 9600
Data bit: 8
Stop bit: 1
Parity: none
Handshake: HWshort
Printer: Epson 80x60
see printer manual
HP Deskjet
with serial in-
terface
6.2125.050
or adapter ca-
ble 25-pol.neg.
/ 9-pol.pos.
(e.g. HP
C2933A) Baud rate: 9600
Data bit: 8
Stop bit: 1
Parity: none
Handshake: HWshort
Printer: HP Deskjet
DIP switch settings:
A B
on
off
1 2 3 4 5 6 7 8 1 2 3 4 5 6 7 8
HP Laserjet
with serial in-
terface
(and compati-
bles)
6.2125.050 or
adapter cable
25-pol. neg. /
9-pol. pos. (e.g.
HP C2933A) Baud rate: 9600
Data bit: 8
Stop bit: 1
Parity: none
Handshake: HWshort
Printer: HP Deskjet
see printer manual
HP Deskjet/
Laserjet
with parallel
interface
6.2125.020 +
serial/ parallel
converter
2.145.0300 Baud rate: 9600
Data bit: 8
Stop bit: 1
Parity: none
Handshake: HWshort
Printer: HP Deskjet
see printer manual
2.6.8 Connecting a bar-code reader
Barcode
D
A bar-code reader can be connected to the bar-code reader socket on the
rear panel of the Titroprocessor. It can be used as a data input and trans-
mits the coded data directly to the keyboard buffer of the Titroprocessor.
The plug occupancy and the transmission parameters of the reader must
correspond with the Metrohm specifications, see page 284. Please consult
your local Metrohm agency to obtain a list of recommended bar-code read-
ers.
2.6.9 Devices on the remote interface
External peripheral devices such as pH meters, pumps, etc. can be con-
trolled via the remote interface (25-pole socket) of the Titroprocessor. Each
717 Sample changer also has a remote socket which can be controlled via
the 'External bus'.