Metrohm 726 Titroprocessor - Manual (Page 211)

8. Command reference 8. Command reference
726 Titroprocessor, Instructions for use 205 205
8.13.4 Other communication commands
Further communication commands are available for special applications.
PRINT
Print out text line
The PRINT command prints out a single line on the printer defined in the
configuration.
Command Parameters Parameters
ДДДДДДДДДДДДД ДДДДДДДДДДДДДДДДДДДДДДДД ДДДДДДДДДДДДДДДДДДДДДДДД
PRINT
Parameter
Text line
up to 50 characters
Any letters, numbers and special characters can be en-
tered.
KEYCTRL
Switch key remote control mode on/off
In order to allow the remote control of the 726 Titroprocessor by a computer
it is possible to switch the communication mode of an RS 232 interface to
the key simulation mode KEYCTRL during a method run. In this mode the
Titroprocessor keyboard is blocked. The instrument can only be operated
via the RS 232 interface.
Command Parameters Parameters
ДДДДДДДДДДДДД ДДДДДДДДДДДДДДДДДДДДДДДД ДДДДДДДДДДДДДДДДДДДДДДДД
KEYCTRL State off