Metrohm 726 Titroprocessor - Manual (Page 33)

22. . Installation Installation
726 Titroprocessor, Instructions for use 27 27
The data transmitted from the balance are directly interpreted by the 726 Ti-
troprocessor within the permitted input range for the sample weight includ-
ing sign and decimal point. The units given in the following table are also
accepted:
Gram g
Milligram mg
Kilogram kg
Pieces pcs
Pieces PC
Carat ct
Pound lb
Ounce oz
Troy ounce ozt
Grain GN
Pennyweight dwt
Any control characters which the balance may transmit will cause the Titro-
processor to produce an error message. Switch off all your balance's auto-
matic status messages when it is connected to the 726 Titroprocessor.
With the aid of a special input unit supplied by the balance manufacturer it is
possible to enter the sample identification and method from the balance as
well as the sample weight. This is done by preselecting the addresses of the
identification and method on the input unit.
Balance Balance Method Method Ident1 Ident1 Ident2 Ident2 Ident3 Ident3
Sartorius METH or 27 ID.1 or 26 ID.2 or 24 C-20 or 23
Mettler (AT) D (Mthd) C (ID # 1) B (ID # 2) A (c20)
Units which are not listed and
which are transmitted directly
after the weight cannot be in-
terpreted and will therefore be
rejected.