Verify the parameter changes – Rockwell Automation 2094-xMxx-S Kinetix 6000 Multi-axis Servo Drives User Manual User Manual
Page 232
232
Rockwell Automation Publication 2094-UM001H-EN-P - June 2013
Appendix C
DC Common Bus Applications
The save to nonvolatile memory is complete and this confirmation
message dialog box opens.
4. Click OK.
5. Close the DriveExplorer software.
Verify the Parameter Changes
Follow these steps to verify your parameter change was successful.
1. Open your DriveExplorer software.
2. Cycle the drive control power.
3. Reconnect the drive to your DriveExplorer software and read the Add Bus
Cap value just like you did in Set the Additional Bus Capacitance
Parameter on
.
4. Verify the new parameter value.
In this example, the new value is 1780 μF.
5. Close the DriveExplorer software.
TIP
Verifying the parameter change is optional.
This manual is related to the following products: